Icom will contact the customer with the repair estimate. Minimum one hour labor fee of $92.40, plus any parts replaced. Products outside the Icom America warranty period will incur a You and Icom America will return equipment FedEx Ground. Prior to shipping any equipment to Icom America’sįreight (insured) to the Icom Repair Center nearest If you are sending in a Limited Edition IC-7850 for service without the protective sheet applied, please call the Icom America Service Department – Washingtonĭownload the IC-7610 proper packing instructions document here. Icom recommends contacting the local repair center before sending in older Icom radios to verify parts availability.Ĭlick here for a list of no longer supported products.
Some out of warranty products may be non-repairable due to parts no longer available.
Handle warranty repair service for most Icom products in warranty. Otherwise, if your rig is as mine, you won't get a decent audio level on your AM transmission.Icom America’s Repair Centers handle all evaluation and repairs The ACC1 audio is better, yes, but not so noticeable.īy the way, if you transmit on AM, I suggest to increase R426 to at least 4.7kOkm (in order to get similar TX audio gains on AM and SSB) and to reduce R449 to 7.8KOhm or so (to get full 100% AM modulation depth without reaching the opamp positive output rail). I suggest you do it only if you're comfortable with this level of hacking.Īnyway, with the mod I described you'll get quite some bandwidth just using the front mic connector. I've changed a few components on my rig to get high-fidelity audio though ACC1 and this required to remove the whole board form the rig and change two or three SMD resistors and capacitors. On the MAIN UNIT board there is an opamp (IC503b) which works near saturation and also has some high-pass filtering on it. Just a tip on the ACC1 audio: The rig, as it is, will give you a low audio fidelity through this connector, as it is intended for digital-like signals only. Could someone provide me the info with the right capacitor to use, a pic or diagram of the XLR cable connector made would be appreciated.Īny info or help would be appreciated and gratefully received. 001uf capacitor to use and if you solder one capacitorįor every pin/shield.
001uf capacitors as suggested but not sure I've brought some Starquad Canare cable and XLR connectors as I'm wanting to I've got the DEQ2496 set up, thanks to all the info here and on the web butĬould someone please give me basic starting settings for the MIC2200 if I'm connecting the ibox audio out cable via the back of the Icom through the New set up will be to start with (hope config is right) Sounds good and get good reports but need/addicted to the TX/RX Bandwidth I've got an Icom 756(non pro) to mod to get the voodoo audio.
0 kommentar(er)
